8350A Operating Manual
Introduction Congratulations and a thank you for the purchase of this Genelec Smart Active Monitor (SAM) system. This manual addresses the stand-alone setup and use of the 8350A SAM monitor. These monitors can also be set up and used with the Genelec Loudspeaker Manager GLM™ and the proprietary Genelec monitor control network and software, offering much more versatile acoustic settings and features. Use with the GLM™ is described in the GLM™ System Operating Manual.
DIP SWITCHES FOR STAND-ALONE USE ROTARY LEVEL CONTROL POWER SWITCH ON OFF -4 ON OFF -2 -6 0 dBu 800 20k LED DISABLE ISS A DIGITAL B -10 dB -20 dB STORED (dB) TREBLE TILT 4k LEVEL BASS TILT DESKTOP BASS ROLL-OFF 160 BASS ROLL-OFF 20 ALL OFF -2 -4 DESKTOP 160 Hz -4 -2 BASS TILT -4 +2 TREBLE TILT -4 +2 SMART ACTIVE MONITOR +2 0 -2 -4 -6 dB +6 +4 INPUT dBu PRODUCING 100 dB SPL (1 m) RESET TO FACTORY SETTINGS: PUSH BUTTON FOR 10 SEC Frequency (Hz) AUDIO SIGNAL CONNECTORS: MAINS INPUT GL
>0 ,7 m h ACOUSTIC AXIS 8350A: h=290 mm (11 1/2 in) Figure 3. The location of the acoustic axis is on the centerline of the monitor at the given height “h”. m Min 5 c Max 60 cm Avo > 60 cid m Figure 5. Recommended distances from a single wall to the front baffle of free-standing monitors. Correct (green) and not recommended (red). necessary when the monitors are placed near room boundaries. The attenuation levels are -2 dB, -4 dB and -6 dB. Treble Tilt Control Figure 4.
Colour Indication Solid greed Normal state, normal operation Blinking green GLM is adjusting the monitor Green blink every 10 sec. Monitor is an ISS power saving sleep state Red blink Power amplifier overload protection is active (audio is modified because of protection) Solid red Monitor is muted Yellow Monitor is not in the active (playing) group Yellow blinking Overheat protection is active (audio is modified because of protection) Table 2.
Genelec Oy 8350A 31 March 2016 Genelec Oy 8350 horizontal off axis response level (dBr) vs freq (Hz) 9 Mar 16 90 100 85 95 90 80 DESKTOP LF d B r 85 90 0° 15° 85 30° 80 A 80 BASS TILT 45° 90 75 60° 85 70 80 TREBLE TILT BASS ROLL-OFF d B r 65 60 55 A 20 50 100 200 500 1k 2k 5k 20k 10k 50 20 50 100 200 500 1k 5k 2k Figure 7.
and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
AMPLIFIER SECTION 8350A Bass amplifier short term output power Treble amplifier short term output power (Long term output power is limited by driver protection circuitry) 200 W 150 W Amplifier system THD at nominal output <0.
