Technical Manual

Generator control is limited to the following output
options (referred to as “Hooks”).
1. Use Keyswitch
2. Force Off – cleared with “Use Keyswitch” hook
3. Force Manual – cleared with “Use Keyswitch”
hook
4. Force Auto – cleared with “Use Keyswitch” hook
5. Force Dialout
6. Halt ILC
7. Force Alarm/Warning #1
8. Force Alarm/Warning #2
9. Force Remote Start
For detail in programming the ILC, refer to the ILC
manual.
THE FRONT PANEL DISPLAY
The front panel display consists of two LCD displays
that are 4 rows of 20 characters each and a key pad
with seven buttons and two LEDs.
LEFT DISPLAY
The left display is used to display a “fixed” set of
parameter pages and has no cursor or entry fields.
The key pad has no direct control of its contents. Its
contents are determined by a menu selection on the
right display.
RIGHT DISPLAY
The right display has several pages and responds
directly to the key pad. There are two “quick” buttons
on the key pad that are used to go directly to either
the Home page or the Menu page. The Enter button
is used to enter and exit edit mode, operate an out-
put override, or select another page. When not in edit
mode, the arrow buttons are used to navigate around
the page to either an edit field or a control field.
When in edit mode, the up/down buttons slew up or
down through the available values and the right/left
buttons are used to change to a different digit or edit


field. Moving off an edit field while in edit mode auto-
matically enters the value displayed. Also, while in
edit mode, pressing the Home button will return the
parameter to the last value entered.
LEFT DISPLAY PAGES
The left display has five “fixed” parameter pages:
System Voltages, System Power, Transfer Switch
Mimic Diagram, Generator Frequency Graph, and
System Alarm Log. A sixth page is selectable, but has
no function at this time. The left display page is deter-
mined by selecting the right display menu item, “Left
Display”. To change the left display, do the following:
Press the “MENU” button.
Press the  button to move to the “Left Display”
field.
Press the “ENTER” button to display the “Left
Display” menu page.
The “>…..<” indicates which page is currently dis-
played on the left display. Use the arrow buttons to
move the cursor to the desired page name and press
the “ENTER” button. The left display will change
to the new page and the “>…..<” will move to the
selected page name.

11
General Information
H-100 Control Panel Technical Manual