Technical Manual

33
Use the up and down arrow key until a “Y” appears.
Press the “ENTER” button to exit edit mode.
Setup of Normal Exercise with transfer to load dur-
ing exercise is now complete. For this example, exer-
cise will start every Wednesday at 10:30 AM and run
until about 10:50 AM. However, the HTS settings may
change this time.
While normal exercise is running, the “Time
Remaining” will display the approximate number of
minutes left before exercise is completed.
SET DATE AND TIME
The H-100 Control Panel contains a real time clock to
keep track of date and time. This is used to schedule
internal exercise, time stamp alarm/event log entries,
and time stamp reports. The date and time can be
changed using either GenLink or the front panel
display.
DATE AND TIME SETUP USING GENLINK
Connect to the H-100 control panel.
The date and time field is displayed in the lower left
corner of the screen.
Using the mouse cursor, click on the date and time
field.
Any of the fields are editable. Note that hours are
entered as 0 – 23. If the PC being used has reliable
date and time settings, pressing the “Synchronize
with PC!” button will copy the PC date and time into
the H-100 Control Panel. Otherwise, press “Apply”
after making changes. The date and time on the
GenLink screen may take a few seconds to update.
DATE AND TIME SETUP USING FRONT PANEL
Press the “MENU” button.


General Information
H-100 Control Panel Technical Manual