Technical Manual

H-100 DIGITAL OUTPUTS

H-100 GenLink

Number Number Signal Description Connector Pin

1 1 Starter Relay (reserved) J1-23

2 2 Fuel Relay (reserved) J1-11

3 3 Fault Relay (reserved) J1-34

4 4 13.3L Gas Relay (reserved for ILC on 13.3L gas) J1-22

5 5 Auxiliary #1 J2-23

6 6 Auxiliary #2 J2-22

7 7 Auxiliary #3 J2-33

8 8 Auxiliary #4 J2-21

9 9 13.3L Ignition Module (reserved for ILC on 13.3L gas) J2-32

10 n/a Overspeed Shutdown (reserved – no software control) J1-10

11 28 Throttle Driver PWM (reserved for H-100 governed generators) J1-33

12 25 PreHeat Relay – diesel only (reserved) J1-21

26 Air/Fuel Ratio PWM – gas only (reserved)

13 31 AVR Field Control (reserved) J2-20

14 32 AVR Field Control (reserved) J2-8



H-100 DIGITAL INPUTS

Number Default Signal Name Signal Description Connector Pin

1 AUTO SWITCH Key Switch in AUTO J2-5

2 MANUAL SWITCH Key Switch in MANUAL J2-28

3 EMERGENCY STOP Emergency Stop Status J2-16

4 REMOTE START Remote Start J2-4

5 DI1/USR CFG 05 DI-1, J2-27

BAT CHRGR FAIL Battery Charger Fail

6 DI2/USR CFG 06 DI-2, J2-15

RUPTURED BASIN Ruptured Basin,

PROP GAS LEAK Propane Gas Leak,

DI2/FUEL PRESSURE Low Fuel Pressure

7 DI3/USR CFG 07 DI-3, J2-3

DI3/LINE POWER Line Power

8 DI4/USR CFG 08 DI-4, J2-26

DI4/GEN POWER Generator Power

9 MODEM DCD Modem DCD J1-14

USR CFG 09 User conﬁ gurable (reserved if Modem)

10 MODEM ENABLED Modem Enable J1-26

11 GEN OVERSPEED Generator Overspeed Detected Internal



Appendix B

H-100 Control Panel Technical Manual