Manual

• Secure tray to handle with self tapping screws usinga

#2 phillips screwdriver. Ensurescrews are tight but not

crushing the plastic accessory tray.

• Placethe handle assembly onto the handle supports

connected to the main unit. Make sure the holes in the

handle alignwith the holes on the handle supports

(Figure 2).

Atig

Handle

Supports

NOTE: It may be necessaryto move the handle supports

from side to side in order to align the handle so it will slide

over the handle supports.

• Insert the "L" bolt through the hole on the right side of

the handle (viewing from rear of unit) and attach the

plastic knob. Tighten the knob by hand (Figure 3).

: .

S'-

• Insert the carriage bolt through the left side hole from

the outside of the unit and attach a plastic knob from the

inside of the unit (viewing unit from the rear). Tighten by

hand (Figure 3).

• Insert the "J"hook into the second from the left slot in

the accessory tray (Figure 4).

• Pinch the chemical hose and slide it into the metal clip as

shown in Figure 5.

• Tilt the unit up by the handle and attach the metal clip to

the rib on the center undersideof the accessory tray

(Figure 6). Slide the chemical hose through the metal clip

so that it is tight but not kinked.

Add Engine Oil

IMPORTANT: Any attempt to crank or start the engine

before it has been properly serviced with the

recommended oil may result in an engine failure.

• Place pressure washer on a levelsurface.

• Refer to the engine owners manual to add recommended

oil to engine.

NOTE: Check oil often during engine break-in. Refer to

engine owner's manual for recommendations.

Add Gasoline

_IL WARNING! Never fill fuel tank indoors. Never

fillfuel tank when engine is running or hot. Do Not

smoke whenfilling fuel tank.