® Owner’s Manual For Surge Protection Device Model Number G0073000 – 120/240V Single Split-Phase SAVE THIS MANUAL FOR FUTURE REFERENCE
WARNING CANCER AND REPRODUCTIVE HARM www.P65Warnings.ca.gov.
Table of Contents Section 1: Safety Introduction ..........................................................1 Read This Manual Thoroughly ....................................1 Safety Rules .........................................................1 Electrical Hazards ................................................1 Section 2: General Information, Specifications, and Warranty Equipment Description .......................................3 Specifications ......................................................
This page intentionally left blank.
Safety Section 1 Safety Introduction Thank you for purchasing a Generac Power Systems Inc. product. This unit has been designed to provide high performance, efficient operation, and years of use when maintained properly. WARNING Indicates a hazardous situation which, if not avoided, could result in death or serious injury. (000002) Read This Manual Thoroughly CAUTION WARNING Consult Manual. Read and understand manual completely before using product.
Safety This page intentionally left blank.
General Information, Specifications, and Warranty Section 2: General Information, Specifications, and Warranty Equipment Description Warranty The Surge Protection Device (SPD) is designed to be installed on service entrance, branch panels, and/or individual equipment disconnects, and functions to protect sensitive electronic equipment from damaging voltage transients. The connecting wires do not carry supply current. Instead, they carry only short-duration currents associated with a transient event.
General Information, Specifications, and Warranty This page intentionally left blank.
Installation and Operation Section 3: Installation and Operation Introduction to Installation This section describes how to install a Surge Protection Device (SPD) in parallel (shunt) across the AC supply of a split phase electrical system. Installation Refer to the label on the SPD to verify the voltage rating and wiring configuration of the SPD matches that of the electrical system. Use an AC voltmeter to measure the system line voltage to verify the correct model of SPD is being installed.
Installation and Operation Operation 1. Apply system power. The LED should illuminate. NOTE: If the connected LED does not illuminate, remove power, check connections, and test again. If the LED still does not light, contact an IASD. 2. The SPD will automatically begin to protect downstream electrical devices from damaging voltage transients. With all phase voltages present, the LED indicator reports the status of the protection elements and is active when all of them are intact and providing protection.
® Part No. A0000384126 Rev. A 10/01/2019 ©2019 Generac Power Systems, Inc. All rights reserved. Specifications are subject to change without notice. No reproduction allowed in any form without prior written consent from Generac Power Systems, Inc. Generac Power Systems, Inc. S45 W29290 Hwy. 59 Waukesha, WI 53189 1-888-GENERAC (1-888-436-3722) www.generac.