Product Manual
Table Of Contents
- Section 1: Safety Rules & General Information
- Section 2: General Information and Setup
- A complete specification sheet is included in the documentation provided with the unit at the time of purchase. For additional copies, contact your nearest authorized dealer, or contact Generac Customer Service at 1-888- 436-3722 (1-888-GENERAC), or ...
- Emissions
- Remove Contents from Carton
- Installing Brush Deck
- Removing Brush Deck
- Maintenance Meter Installation
- Adding Oil
- Adding Fuel
- Checking Tire Pressure
- Connecting Battery Cable
- Handlebar Height Adjustment
- Deck Pivot Bolt Check/Adjustment
- Steering Brake Burnishing
- Blade Clutch Burnishing
- High Altitude Replacement Kit
- Section 3: Operation
- Operation and Use Questions
- Controls and Symbols
- Before Starting Engine
- Starting Unit
- Engaging Wheel Drive
- Engaging Mower Blade
- Disengaging Mower Blade
- Stopping the Engine
- Operating Steering Brakes
- Steering wit h Brake Assist
- Traction Control with Brakes
- Setting Parking Brake
- If Mower Gets Stuck
- Mowing on Slopes
- Deck Pivot Bolt Adjustment for Aggressive Mowing Conditions
- This page intentionally left blank.
- Section 4: Maintenance and Troubleshooting
- Maintenance
- Operating the Maintenance Meter
- Air Filter Maintenance
- Changing Engine Oil and Filter
- Servicing Spark Plug
- Idler Arm Lubrication
- Cable Lubrication
- Adjusting Traction Drive Cable
- Adjusting Shift Cables
- Replacing Drive Belt
- Removing Wheels
- Replacing Mower Blade
- Replacing the Mower Blade Pulley
- Adjusting Brake Cables
- Adjusting Brake Pads
- Adjusting Caliper Alignment
- Battery Care
- Troubleshooting
Owner’s Manual for Field and Brush Mower 7
General Information and Setup
6.
See
Figure 2-7
. Place belt onto deck pulley. Gradu-
ally turn belt pulley to assist belt into pulley groove.
Figure 2-7. Install Belt on Spindle Pulley
7. See Figure 2-8. Install and secure belt guard with
provided hardware.
Figure 2-8. Deck Installation Complete
Removing Brush Deck
NOTE: Only remove the brush deck to install other
attachments, or when performing maintenance.
1. See Figure 2-9. Remove knob (A) securing belt
guard to brush deck, and remove belt guard (B).
Figure 2-9. Belt Guard Knob
2.
Place a screw driver between blade pulley and belt.
3. See Figure 2-10. Rotate blade pulley to roll belt off
blade pulley (C).
Figure 2-10. Removing Belt from Blade
4. See Figure 2-11. Push the belt toward the power
unit, and the belt will fall off clutch pulley (D).
Figure 2-11. Belt Installed
5. Pull the belt toward deck and remove the belt.
6.
See
Figure 2-12
. Remove collar (E) and detent pin (F).
Figure 2-12. Detent Pin and Collar
7. Shift wheel speed lever into neutral.
8. Pull power unit back to remove power unit pin from
deck pivot bracket.
005833
005826
005811
A
B
005833
C
005853
D
005830
E
F