Use and Care Manual

ManualsBrandsGeneral Finishes ManualsCraft & Art Supplies1 qt. Queenstown Gray Interior/Exterior Milk Paint

Queenstown Gray Milk Paint

Section 6. Accidental release measures

Environmental precautions

Avoid dispersal of spilled material and runoff and contact with soil, waterways, drains

and sewers. Inform the relevant authorities if the product has caused environmental

pollution (sewers, waterways, soil or air).

Methods and materials for containment and cleaning up

Stop leak if without risk. Move containers from spill area. Approach release from

upwind. Prevent entry into sewers, water courses, basements or confined areas. Wash

spillages into an effluent treatment plant or proceed as follows. Contain and collect

spillage with non-combustible, absorbent material e.g. sand, earth, vermiculite or

diatomaceous earth and place in container for disposal according to local regulations

(see Section 13). Dispose of via a licensed waste disposal contractor. Contaminated

absorbent material may pose the same hazard as the spilled product. Note: see Section

1 for emergency contact information and Section 13 for waste disposal.

Spill

Section 7. Handling and storage

Advice on general

occupational hygiene

Conditions for safe storage,

including any

incompatibilities

Eating, drinking and smoking should be prohibited in areas where this material is

handled, stored and processed. Workers should wash hands and face before eating,

drinking and smoking. See also Section 8 for additional information on hygiene

measures.

Store in accordance with local regulations. Store in original container protected from

direct sunlight in a dry, cool and well-ventilated area, away from incompatible materials

(see Section 10) and food and drink. Store locked up. Keep container tightly closed

and sealed until ready for use. Containers that have been opened must be carefully

resealed and kept upright to prevent leakage. Do not store in unlabeled containers.

Use appropriate containment to avoid environmental contamination. See Section 10 for

incompatible materials before handling or use.

Protective measures

Put on appropriate personal protective equipment (see Section 8). Avoid exposure -

obtain special instructions before use. Do not handle until all safety precautions have

been read and understood. Do not get in eyes or on skin or clothing. Do not ingest.

Avoid breathing vapor or mist. If during normal use the material presents a respiratory

hazard, use only with adequate ventilation or wear appropriate respirator. Keep in the

original container or an approved alternative made from a compatible material, kept

tightly closed when not in use. Empty containers retain product residue and can be

hazardous. Do not reuse container.

Precautions for safe handling

Titanium dioxide

ACGIH TLV (United States, 3/2017).

TWA: 10 mg/m³ 8 hours.

OSHA PEL (United States, 6/2016).

TWA: 15 mg/m³ 8 hours. Form: Total dust

Propane-1,2-diol

AIHA WEEL (United States, 10/2011).

TWA: 10 mg/m³ 8 hours.

(2-Methoxymethylethoxy)propanol

ACGIH TLV (United States, 3/2017). Absorbed through skin.

TWA: 100 ppm 8 hours.

TWA: 606 mg/m³ 8 hours.

STEL: 150 ppm 15 minutes.

STEL: 909 mg/m³ 15 minutes.

NIOSH REL (United States, 10/2016). Absorbed through skin.

TWA: 100 ppm 10 hours.

Section 8. Exposure controls/personal protection

Ingredient name

Exposure limits

Control parameters

Occupational exposure limits

United States

4/12

Tel : +1-888-GHS-7769 (447-7769) / +1-450-GHS-7767 (447-7767)