Use and Care Manual

BLADE

SHOULDER

3. Loosen the blade by turning the handwheel coun-

terclockwise.

4. Adjust the wheel tilt by turning the screw A with a 4

mm Allen key, so that the blade stays against the

shoulder of the pulley. Tighten two bolts B, close the

blade cover and tension the blade.

SQUARING THE BLADE TO THE WORK TABLE

1. Lower the arm into the horizontal position and then

place a square against the vise face and against

the blade as shown E. If the blade is not square to

the table go to the step 2.

2. Loosen screw C with a 6 mm Allen key and make

sure that the blade is parallel with the square by

turning the blade support D. Retighten screw C

once ﬁnished adjusting. Repeat with the second

support on the other side.

WORK TABLE

BLADE

SQUARE

WORK TABLE

BLADE

SQUARE

MAKE SURE THE MACHINE HAS BEEN TURNED OFF AND UNPLUGGED FROM THE POWER SOURCE BEFORE PERFORM-

ING ANY MAINTENANCE OR ADJUSTMENTS.

ADJUSTING BLADE TRACKING

(CONTINUED)

SQUARING THE VISE TO THE BLADE/USING THE VISE

1. Lower the arm into the horizontal position and place

a square against one of the jaws and the blade as

shown.

Note: The blade must be perfectly squared to the

vise F. If the blade is not squared, go to the next step.

The vise can accommodate workpieces up to 7“ wide. Adjust the angle of cut or square the vise to the table as follows:

SQUARE

ISE

SQUA

LADE