Use and Care Manual

CHANGING THE BELT & ALIGNING THE PULLEYS

1. Lower the arm into the horizontal position and loos-

en the jam nut and bolt A with a 12 mm wrench.

2. Loosen jam nuts B and bolts C with a 12 mm wrench

until the motor base can be moved.

3. Open the pulley cover and change the belt.

Note: if there is not enough slack to move the belt,

loosen tension screws C as needed.

4. Place a straightedge on the two pulleys as shown D

to verify their alignment.

5. If the pulleys are not aligned, loosen the four bolts

E and F located on the motor mounting plate, and

then re-position the motor along the slotted mount-

ing holes so that the pulleys are aligned.

6. With the pulleys aligned, retighten the four bolts E

and F.

7. Retighten the two bolts C alternating one turn at a time until the belt is tensioned properly. Then secure the mo-

tor in position by tightening the jam nuts B and the jam nut and bolt A.

8. Close the pulley cover.

MAKE SURE THE MACHINE HAS BEEN TURNED OFF AND UNPLUGGED FROM THE POWER SOURCE BEFORE PERFORM-

ING ANY MAINTENANCE OR ADJUSTMENTS.

NOTES

TIP: CHECK THE TENSION BY PUSHING GENTLY THE BELT

WITH YOUR FINGER. THE BELT SHOULD NOT MOVE MORE

THAN 1/2”.