Operation Manual

5 - 14
Owner's Manual
Styles, Songs & Sequencer
Programmable Styles
Pnch: refers to “Punch” - this is a typical Sequencer function that permits
you to correct mistakes by “Punching in” a correct note or sequence
of notes into the recorded track with the aid of one of the Pedals
programmed for the relative function.
The LENGTH function
This parameter determines the number of bars for the Riff.
From 1 to 8 bars can be programmed for each Riff. You can also record two
different Riffs with two different bar lengths.
Important: You cannot change the value of this parameter in a recorded
Riff.
Once you have recorded a Riff with a certain bar length, an attempt to change this
value will display the following message:
CHANGING THE SOUND ASSIGNED TO THE TRACK
Before starting the recording, you can assign a different sound to the Track in record but,
unless you Save the modification (press ENT twice), the playback will recall the original
sound with which you entered recording.
You can also change sound during the recording; the Program Change will be recorded
in the Track
1
, but be careful: the relative Performance modification will not be
recorded therefore, when the riff loops back to the beginning, the original starting sound
will not be recalled because the last change will remain.
You can rectify this by changing back to the original sound at the very last instant, just
before riff loops back to the beginning. The change will be recorded in the track and the
Riff cycle will start with the original sound.
6. Access the Master Track to specify your required Time Signature and to modify
other parameters.
In Style Mode, the Master Track behaves as a “seventh track” and records general
controls common to all tracks.
At this stage, before proceeding with your recording, you can change the status of
one or more of the parameters.
Select the parameter with the Cursor Up/Down arrows and use the Dial or Toggle
to change the parameter status.
Note:
You can record two
different Riffs, each
with different lengths.
SEQ. EDIT
MASTER COPY MOVE
ERASE
INS/DEL TRANSP
QUANT MICRO NAME
OPTION UNDO DEMO
Note 1:
If you change the sound
of a Track of the
recorded Style, you
must SAVE the change
in the Style
Performance (press
ENT twice). If the
modification is not
saved, when you press
Start, the recorded Style
Performance will recall
the Sound with which
the Track was recorded.
HINT
It is best to program
one of the Logic pedals
for Punch operation
before entering Record
mode. This will save
time and avoid escaping
the mode to set the
function.
Downloaded from www.Manualslib.com manuals search engine