Operation Manual

6 - 16
Owner's Manual
Edit Sequencer
Sequencer
MICROSCOPE (Event Edit)
A single step of musical data is called an “event”. The Microscope Event Edit operations
permit you to modify, insert or delete individual events from the data in a Track. Insert
also allows you to insert Control Data not otherwise possible in Realtime record mode.
Since event edit allows direct access to sequence data, careless editing can modify your
recorded data so that it can no longer be restored to its original state. You are advised,
therefore, to use caution.
A description of the display elements shown:
Bar song pointer which defines the position of the event.
Status indicates the type of event recorded:
◆ Note
◆ Program Change
◆ Pitch Bend
◆ Controllers
◆ Mono Touch
◆ Poly Aftertouch
1V, 2V, 3V these parameters assume values according to the type of
event shown in Status.
GT indicates the note length (gate time). This parameter only
applies to the notes and is ignored by all other events.
Navigation
◆ Use the Cursor arrows to move up down and across the display.
◆ If you scroll with the Up/Down arrows, each note will be played.
◆ Use the Dial to modify the selected parameter
◆ Use the Toggle to access a parameter value and specify a new value using the keys
on the keyboard corresponding to the numbers 0 - 9.
When Status = Note:
1V specifies the note number with values C-1...G9.
If you rotate the Dial when the cursor is at the song pointer’s Bar location, you can
hear all the recorded notes in order of appearance.
If you rotate the Dial when the note number is selected, you can hear all the notes
selected.
Downloaded from www.Manualslib.com manuals search engine