Operation Manual

Owner's Manual
1 - 11
Getting Started
[Left, Right/M] jacks. There is also a facility available in the Mixer function to control
the Treble, Bass and Volume of the incoming audio signal.
CONTROL PEDALS - CONNECTION OF THE FOOTPEDALS
WX has two jacks (Pedal 1 - Pedal 2) which can be programmed to accept Switch
Control pedals (logic) or Continuous Control pedals (analog), a third jack for a Switch
Control pedal (logic) marked Damper and a Continuous control jack marked Volume,
preset to control the standard MIDI Foot command - MIDI O4.
The default status of the programmable jacks varies according to the instrument.
In WX2 (all optional): Pedal 1 = Volume - Pedal 2 = Start/Stop - Damper = Damper
In WX400:Pedal 1 = Soft - Pedal 2 = Sostenuto - Damper = Damper.
The pedals in model WX400 are enclosed in the pedal cross-bar of the instrument. To
connect the Pedals, follow the assembly instructions at the begining of the owner’s
manual. The jacks are marked 1, 2 and 3 where jack 3 refers to the Damper.
The three Pedal jacks Pedal 1, Pedal 2 and Damper are all function assignable and have
reversible polarity options, allowing the connection of pedals of different brands.
PEDALBOARD
You can connect a Pedalboard to this jack.
MIDI CONNECTIONS
The MIDI implementations are one of the attractions of WX, which makes it an excellent
MIDI controller. Both models are fitted with a MIDI IN, a MIDI THRU and two MIDI
OUT ports (Out 1 - Out 2).
The WX2/WX400 Keyboard will respond to Note messages transmitted to MIDI IN for
all notes C-1 – G9 (note numbers 0 - 127). In some cases, the higher notes will not sound.
HEADPHONES
Both WX models have a headphone jack on the left front edge of the instrument, below
the Track-ball.
Connect a pair of headphones for private listening without disturbing others in the same
room. The headphone Volume is controlled by the Master Volume slider. Inserting the
headphone jack disconnects the internal speakers but does not affect external amplifica-
tion if used.
THE VIDEO INTERFACE - VIDEO OUT JACKS (TV and RGB)
These two rear-panel outputs provide various possibilities of interfacing with a monitor.
If you possess an “ATARI” type colour monitor, the 13 pin DIN connector marked RGB
sends a signal which is compatible (100%) with the standard adopted by the said monitor.
For high quality images therefore, it is sufficient to connect the monitor directly to the
WX RGB connector using the cable supplied with the monitor.
To connect your WX to a domestic TV screen, the latter must be equipped with a SCART
connector, or a COMPOSITE VIDEO jack. In the first case, you can connect the RGB
output directly to the SCART connector by means of the supplied video cable. In the
IMPORTANT:
The VIDEO outputs
are operative only if
the instrument is fitted
with the optional
VIDEO INTERFACE
(a small printed
circuit).
Models not equipped
with the V.I. are
identified by a remov-
able label applied near
the rear panel Video
Out sockets.
Downloaded from www.Manualslib.com manuals search engine