Operation Manual

4 - 6

Owner's Manual

Edit Section

Disk & SRam

NOTE 1:

The entire contents of

SRam are loaded

automatically when the

instrument is turned on.

LOAD OPERATIONS

Use the LOAD function to load the contents of your Disks, or of the Static RAM, into

the instrument's memory

. When you load data, the data previously in internal memory

will be overwritten and lost.

The four main LOAD operations are:

Load All - Load Bank - Load Single and Preload.

1. LOAD ALL DISK (or all SRAM)

1.1 This mode loads all data (except MIDI files) from the inserted Disk or from

SRam into the internal Memory:

1.2 Confirm the operation with ENTER.

The "WAIT PLEASE" message appears together with an animated clock indicating

that WX is examining the type of disk inserted or the type of data in SRam:

1.3 If the disk is a WX disk, you will be asked to confirm the operation before

proceeding. If you are performing an SRam operation, the same message

will be displayed:

1.4 Confirm with ENTER or quit the operation with ESC.

Confirmation of the operation is indicated by the "Loading" message

, the

animated clock, the green disk drive led and a familiar noise from the driver. Both

Disk and SRam operations show the same message:

When the message at the centre of the display disappears and the driver led turns

off, your data will be loaded.

NOTE 2:

Loading times

Loading times depend

on the disk contents and

the type of data loaded.

Times vary from 1

second to

approximately 1 minute.

N.B. the “Wait Please”

message does not

appear when you load

data from SRam into the

instrument's internal

memory.

Downloaded from www.Manualslib.com manuals search engine