Operation Manual

Owner's Manual
4 - 47
Edit Section
Effects 1 & 2
The remaining Reverbs, with programmable Early Reflections, show a slight variation:
Early1_1, Early2_1, Early3_1, Stereo1_1, Stereo2_1, Stereo3_1, Stereo4_1.
1. VOLUME: The primary Reverb level; setting this parameter to “0” cancels
the action of the Reverb.
Value range 0[-63.50dB] ... 127[0.0dB].
2. ROOM SIZE: Establishes the dimensions of the environment.
Value range: 0..64).
3. DIFFUSION: Creates a reverberation halo in the final part of the effect.
Value range: 0... 60.
4. FILTER: Cutoff frequency of the filter.
Value range: 0[Bypass], 1[0.1 khz] ... 13[16 khz].
EFFECT 2 - DELAY, MODULATIONS
Effect 2 contains the Delay/Echo and the Modulations (Chorus, Flanger, Phaser, Rotary
Speaker, etc.). These Effects provide a greater number of different parameter configu-
rations.
The Effects listed below all provide the same edit parameters:
Delay1_1, Delay1_2, Delay2_1, Delay2_2, Panecho1, Panecho2, Panecho3,
Dubbing_1.
1. VOLUME: The primary Delay level; setting this parameter to “0” cancels
the action of Delay, PanEcho or Dubbing.
Value range 0[-63.50dB] ... 127[0.0dB].
2. DELAY: Determines the time lapse between repetitions.
Value range: 0...510 ms.
3. FEEDBACK: Determines the number of Delay repetitions. With a delay time
of ‘510ms’ and this parameter set at 99%, the total duration of
the effect is 11 seconds.
Value range: 0[4%] ... 14[99%].
4. FILTER: Determines the timbric quality of each repetition and progressively
inserts a lowpass filter. A high value filter reacts very slowly while
a modest value increases the speed of the timbric change.
Value range: 0[Bypass], 1[0.1 khz]... 12[16 khz].
NOTE:
PanEcho is a Delay/
Echo in which the
repetitions alternate
between the two stereo
channels.
Dubbing sends all the
repetitions to only one
output channel.
Downloaded from www.Manualslib.com manuals search engine