Operation Manual
(see 1, pg. 3)
1. Receiver
2. Remote control
3. Power cells ААА, 1.5 V for remote control (2 pieces)
4. User Manual
5. HDMI connecting cable
Complete set of delivery can vary depending on the region.
(see 2, pg. 4)
1. STANDBY BUTTON
Switching-on and switching-o of the Receiver. The button is intended for switching of the Receiver
from standby mode (Stand By) into operating mode and vice versa. The «Stand By» mode indicator (red),
operating mode (yellow), presence of received signal (green).
2. CHANNEL +/- BUTTONS
Buttons for switching between the channels.
3. TV/R BUTTON
Switching between the modes of receiving of TV and radio channels.
4. CHANNEL NUMBER INDICATOR
Indicates the number of the received channel; the process of loading.
5. CARD READER
If you install a smart-card in this slot, you would be granted an access to coded channels.
6. Common Interface SLOT
CI slot for modules of conditional access.
7. USB
USB connector for updating of the Receiver's software.
(see 3, pg. 4)
1. LNB IN
Connector for connection of the aerial’s cable.
2. LNB OUT
Loop output for connection of another Receiver.
3. ETHERNET
Connector intended for connection of Ethernet cable (not active in all modications).
4. S/PDIF
Digital optical audio output.
58
NOTE!