Operation Manual
87
In this item of the Menu it is possible to restore all values of default settings.
With resetting to default settings, the information about the tuned channels, aerials, lists of favourite
channels would be lost.
To load the default settings, depress the RED button [11] of the remote control. Acknowledge resetting to
the default settings by depressing Yes in the screen window.
After resetting the Receiver will be switched into Standby mode.
This function sets limitations on watching and
prevents unauthorised access to Setup Menu of
your Receiver with the help of PIN-code, which
consists of 4 digits. By default, the PIN-code is set
to value 0000 at the factory-manufacturer. If the
PIN-code is entered incorrectly, you would not be
able to switch to the next mode.
To change the PIN-code select the Menu item of
Change PIN. Here, you would have to enter the
active PIN-code, and near the indicator of New PIN
– enter the new required PIN-code. To acknowledge
the operation, it would be necessary to repeat entry
of the new PIN-code. It is also possible to set age limitation on watching of the various programmes in
this Menu. This function would be active in case where the operator transmits information about age
limitation on watching of his programmes.
Should you forget the PIN-code, you would have to address the service department of the company from
which you have purchased the Receiver therefore make an eort to remember the code.
Time parameters can be adjusted in the Main menu in the item of Timer.
This item is similar to Step 6 of the Installation wizard.
NOTE!