Use and Care Manual

Symbol Description Symbol Description
Application and For measurements
removal from made on building
hazardous live equipment such
conductors as distribution
permitted panels, feeders
and short branch
circuits, and on
lighting systems in
large buildings.
SETUP INSTRUCTIONS
INSTALL BATTERIES
The battery compartment of the DAMP60 and
DAMP68 is located at the back of the meter.
To open the compartment, use a small Phillips-
head screwdriver to remove the single screw
securing the battery compartment cover. Be
careful not to lose the small screw. Put the screw
and the cover to the side.
Install the supplied “AA” batteries (two in the
case of the DAMP60; three for the DAMP68) in
the battery compartment. Use the polarity marks
stenciled inside the compartment as a guide.
Replace the battery compartment cover and
secure it with the Phillips-head screw.
OPERATING INSTRUCTIONS
MEASURING AC OR DC CURRENT
 Warning
Before making current measurements, make
certain that all test leads are disconnected from
the meter terminals.
(1) Set the function switch to the (DAMP60)
or (DAMP68) position. For DAMP68,
AC current measurement is the default mode;
11