Manualshelf

Instructions / Assembly

ManualsBrandsGeneration Lighting Designer Collections ManualsChandeliersED Ellen DeGeneres Crafted by Generation Lighting Haymarket 1-Light Weathered Galvanized Pendant with White Inner Finish
12
1
Installation Instructions for
Haymarket Pendant
1.0
EP1001
Pendant
E 1001, EP1161P
GP I :ENERAL RODUCT NFORMATION
These fixtures are intended to be installed utilizing NEC compliant junction
boxes.
This product is safety listed for damp locations.
Incandescent lamps may be dimmed with a standard incandescent dimmer.
LED lamps may be dimmed with a LED dimmer. Consult lamp manufacturer
for additional information.
This instruction shows a typical installation.
1
2
1A
3
CAUTION RISK OF FIRE-
This product must be installed in accordance with the
applicable installation code by a person familiar with the
construction and operation of the product and the hazards
involved.
Use minimum 90°c supply conductors.
Install the lower shade by placing it onto the spacers on the upper shade, aligning the screw holes, and securing them together
using the cap screws.
If necessary, screw the shorter end of the threaded nipple tightly onto the mounting plate.
Secure the mounting plate to the junction box.
Temporarily unscrew and remove the collar nut, then screw the screw collar tightly onto the threaded nipple.
Install a quick link onto the end of the chain and fixture loop. Determine the wanted height of the fixture and remove a portion of
the chain by opening a link and removing it from the top.
Install the collar nut and canopy onto the chain (in that order), then install the other quick link onto the free end of the chain and
screw collar.
Weave the cord through the chain, screw collar, canopy, threaded nipple, and out of the junction box. Trim the cord leaving
enough to make electrical connections.
Connect the fixture to a suitable ground in accordance to local electrical codes.
Connect the white fixture wire (square and/or rigid) to the neutral power line wire with a wire nut.
Connect the black fixture wire (round and/or smooth) to the hot power line wire with a wire nut.
Neatly place all the wires into the junction box, place the canopy onto the ceiling, and secure it in place by screwing the collar nut
tightly onto the screw collar.
Screw the lamp into the socket. Refer to the label on the socket for Max Wattage information.
4
5
6
7
8
9
10
11
12
10
LAMP
UPPER SHADE
CANOPY
MOUNTING PLATE
JUNCTION BOX
SCREW COLLAR
THREADED NIPPLE
COLLAR NUT
1
6
9
12
CHAIN
QUICK LINK
LOWER SHADE
5
THUMB SCREW

Summary of content (2 pages)