Installation Sheet

ManualsBrandsGeneration Lighting ManualsChandeliersAllier 5 Light 26" Wide Taper Candle Chandelier

Installation Instructions for

Allier 4 and 5 Light Chandelier

1.1

F2935-4-F2936-5

Chandelier

F2935/4, F2936/5

GP I :ENERAL RODUCT NFORMATION

These fixtures are intended to be installed utilizing NEC compliant

junction boxes.

This product is safety listed for dry locations only.

This product may be dimmed with a standard incandescent dimmer.

This instruction shows a typical installation.

Screw the stem to the fixture, then screw the stem to the frame.

Install the candle tubes by slipping them through the sockets.

Screw the lamps into the sockets. Refer to the label on the lamp socket for Max Wattage information.

Follow enclosed supplement installation instructions for electrical and fixture installation onto house outlet box.

LAMP

SOCKET

CAUTION - RISK OF FIRE

This product must be installed in accordance with

the applicable installation code by a person familiar

with the construction and operation of the product

and the hazards involved.

Use minimum 90°c supply conductors.

FIXTURE

CANDLE TUBE

STEM

FRAME

Summary of content (4 pages)

PAGE 1
Installation Instructions for F2935-4-F2936-5 Allier 4 and 5 Light Chandelier F2935/4, F2936/5 Chandelier GENERAL PRODUCT INFORMATION: These fixtures are intended to be installed utilizing NEC compliant junction boxes. This product may be dimmed with a standard incandescent dimmer. CAUTION - RISK OF FIRE This product must be installed in accordance with the applicable installation code by a person familiar with the construction and operation of the product and the hazards involved.
PAGE 2
ATTENTION : RISQUE D'INCENDIE Ce produit doit être installé conformément au code d'installation en vigueur par une personne familière avec la construction et l'exploitation du produit et les risques qu'il entraîne. Utiliser les conducteurs d'alimentation supérieure à 90° c. 1A 4 CADRE 1 TIGE 3 AMPOULE 2 TUBE BOUGIE DOUILLE 1 LUMINAIRE 1 Vissez la tige sur le luminaire, puis vissez la tige à le cadre. 2 Installez le tubes de bougie en les glissant à travers le douille.
PAGE 3
PRECAUCIÓN: RIESGO DE INCENDIO Este producto debe instalarse de acuerdo con el código de instalación aplicable por una persona familiarizada con la construcción y operación del producto y los riesgos que conllevan. Utilizar conductores de suministro mínimo 90° c. 1A 4 MARCO 1 TALLO 3 BOMBILLA 2 TUBO DE VELA ENCHUFE 1 LÁMPARA 1 Atornillar el tall y la lámpara, luego atornillar el tallo a la asamblea superior. 2 Instale el tubo de vela deslizándolo a través de el enchufe.
PAGE 4
SAVE THESE INSTRUCTIONS! 555 Theodore Fremd Ave Suite B101 Rye, NY 10580 800.969.3347 www.Feiss.com © 2015 Feiss.All rights reserved.The "Feiss" graphic is a registered trademark of Feiss. Feiss reserves the right to change specifications for product improvements without notification.