Installation Guide

ManualsBrandsGeneration Lighting ManualsChandeliersHartsville 5 Light 24" Wide Taper Candle Chandelier

Installation Instructions for

Hartsville 3, 5, and 9 Light Chandelier

1.1

F2997-3_F2998-5_F2999-9

Chandelier

F2997/3, F2998/5,

F2999/9

GP I :ENERAL RODUCT NFORMATION

These fixtures are intended to be installed utilizing compliantNEC

junction boxes.

This product is safety listed for damp locations only.

This product may be dimmed with a standard incandescent dimmer.

This instruction shows a typical installation.

Feed the cord through the cover and fixture loop, then screw the cover onto the coupler.

Install the candle tubes by slipping them over the sockets.

Install the candle followers by placing them on top of the candle tubes.

Screw the lamps into the sockets. Refer to the label on the lamp socket for Max Wattage information.

Follow enclosed supplement installation instructions for electrical and fixture installation onto house outlet box.

Screw the finial onto the bottom of the fixture.

LAMP

CANDLE TUBE

SOCKET

CANDLE FOLLOWER

CAUTION RISK OF FIRE-

This product must be installed in accordance with the

applicable installation code by a person familiar with the

construction and operation of the product and the hazards

involved.

Use minimum 90°c supply conductors.

FINIAL

COVER

COUPLER

FIXTURE LOOP

Summary of content (4 pages)

PAGE 1
F2997-3_F2998-5_F2999-9 Installation Instructions for F2997/3, F2998/5, F2999/9 Hartsville 3, 5, and 9 Light Chandelier Chandelier GENERAL PRODUCT INFORMATION: These fixtures are intended to be installed utilizing NEC compliant junction boxes. CAUTION - RISK OF FIRE This product must be installed in accordance with the applicable installation code by a person familiar with the construction and operation of the product and the hazards involved. This product is safety listed for damp locations only.
PAGE 2
MISE EN GARDE - RISQUE D'INCENDIE Ce produit doit être installé selon le code d’installation pertinent , par une personne qui connaÎt bien le produit et son fonctionnement ainsi que les risques inhérents Les fils d’alimentation doivent convenir pour 90°c. 1A 5 BOUCLE DE LUMINAIRE 4 COUVERCLE AMPOULE 1 COUPLEUR 3 ADEPTE DE BOUGIE 2 TUBE BOUGIE DOUILLE 6 FLEURON 1 Faites passer le cordon à travers le couvercle et boucle de luminaire, puis visser le couvercle sur le coupleur.
PAGE 3
ADVERTENCIA - RIESGO DE INCENDIO Este productor debe ser instalado segun el codigo de instalacion aplicable por una persona que conozca la constussion y el funcionamiento del producto y los riesgos que supone. Conductores de alimentacion 90°c Min. 1A 5 BUCLE DE LA LÁMPARA 4 CUBIERTA BOMBILLA 1 ACOPLADOR 3 SEGUIDOR DE VELA 2 TUBO DE VELA ENCHUFE 6 FINIAL 1 Pase el cordón por la cubierta y bucle de la lámpara, a continuación, atornille la cubierta en el acoplador.
PAGE 4
SAVE THESE INSTRUCTIONS! 555 Theodore Fremd Ave Suite B101 Rye, NY 10580 800.969.3347 www.Feiss.com © 2015 Feiss.All rights reserved.The "Feiss" graphic is a registered trademark of Feiss. Feiss reserves the right to change specifications for product improvements without notification.