Installation Sheet

1
Installation Instructions for
Gannet Island Chandelier
1.0
F3193-5
F3193/5
GP I :ENERAL RODUCT NFORMATION
These fixtures are intended to be installed utilizing NEC compliant junction boxes.
This product is safety listed for damp locations.
Incandescent lamps may be dimmed with a standard incandescent dimmer.
LED LEDlamps may be dimmed with a dimmer. Consult lamp manufacturer for
additional information.
CAUTION RISK OF FIRE-
This product must be installed in accordance with the
applicable installation code by a person familiar with the
construction and operation of the product and the hazards
involved.
Use minimum 90°c supply conductors.
Chandelier
Temporarily install the mounting plate to the junction box.
Mark the anchor locations through the holes on the mounting plate, then remove the mounting plate.
Install the anchors to the marked points.
Secure the mounting plate to the junction box.
Screw the anchor screws into the anchors.
Determine the height of the fixture with the provided stems and assemble them by screwing them together.
Feed the cord through the stem assembly and screw the stem assemblies to the fixture.
Feed the cord through the swivels and screw them to the stem assemblies.
Feed the cord through the canopy, large canopy plate, washers, and nuts, then place them onto the swivels and secure them together with the
washers and nuts.
Pull the power line wires out of the junction box. Trim the cord leaving enough to make electrical connections.
Connect the fixture to a suitable ground in accordance with local electrical codes.
Connect the white fixture wire (square and/or rigid) to the neutral power line wire with a wire nut.
Connect the black fixture wire (round and/or smooth) to the hot power line wire with a wire nut.
Neatly place all the wires into the junction box, place the canopy onto the mounting plate, and secure it in place with the fixture screws.
Screw the lamps into the sockets. Refer to the label on the socket for Max Wattage information.
1
2
1A
3
4
5
6
7
8
9
10
11
12
1213
ANCHOR
13
14
15
3
7
7
8
8
6
6
FIXTURE SCREW
5
14
15
FIXTURE
SOCKET
LAMP
STEM ASSEMBLY
SWIVEL
MOUNTING PLATE
HEX NUT AND WASHERS
LARGE CANOPY PLATE
ANCHOR SCREW
CANOPY
9
9