Installation Sheet

ManualsBrandsGeneration Lighting ManualsChandeliersGannet 8 Light 26" Wide Taper Candle Chandelier

Installation Instructions for

Gannet Chandelier

1.0

F3191-4-F3192-6-F3194-8

Chandelier

F3191/4, F3192/6, F3194/8

Screw the stems together, then screw the hub to the stems and the stems to the fixture.

Install the fixture arms to the fixture frame and secure them together using screws.

Install the candle tubes by slipping them through the sockets.

Screw the lamp into the socket. Refer to the label on the lamp socket for Max Wattage information.

Follow enclosed supplement installation instructions for electrical and fixture installation onto house outlet box.

CAUTION RISK OF FIRE-

This product must be installed in accordance with

the applicable installation code by a person familiar

with the construction and operation of the product

and the hazards involved.

Use minimum 90°c supply conductors.

LAMP

SOCKET

CANDLE TUBE

FIXTURE FRAME

GP I :ENERAL RODUCT NFORMATION

These fixtures are intended to be installed utilizing compliantNEC

junction boxes.

This product is safety listed for damp locations.

This instruction shows a typical installation.

FIXTURE

STEM

FIXTURE SCREW

HUB

FIXTURE ARM

Summary of content (4 pages)

PAGE 1
Installation Instructions for F3191-4-F3192-6-F3194-8 Gannet Chandelier F3191/4, F3192/6, F3194/8 Chandelier GENERAL PRODUCT INFORMATION: CAUTION - RISK OF FIRE This product must be installed in accordance with the applicable installation code by a person familiar with the construction and operation of the product and the hazards involved. These fixtures are intended to be installed utilizing NEC compliant junction boxes. This product is safety listed for damp locations.
PAGE 2
ATTENTION : RISQUE D'INCENDIE Ce produit doit être installé conformément au code d'installation en vigueur par une personne familière avec la construction et l'exploitation du produit et les risques qu'il entraîne. Utiliser les conducteurs d'alimentation supérieure à 90° c.
PAGE 3
PRECAUCIÓN: RIESGO DE INCENDIO Este producto debe instalarse de acuerdo con el código de instalación aplicable por una persona familiarizada con la construcción y operación del producto y los riesgos que conllevan. Utilizar conductores de suministro mínimo 90° c. 1A 5 1 EJE 1 BRAZO DE LA LÁMPARA 2 TORNILLO DE LA LÁMPARA 4 BOMBILLA TUBO DE VELA TALLO 1 3 MARCO DE LA LÁMPARA 1 LÁMPARA ENCHUFE 1 Atornillar los tallos juntos, luego enrosque el eje a los tallos y los tallos a la lámpara.
PAGE 4
SAVE THESE INSTRUCTIONS! 7400 Linder Ave, Skokie, IL 60077 800.969.3347 www.Feiss.com © 2018 Feiss.All rights reserved.The "Feiss" graphic is a registered trademark of Feiss. Feiss reserves the right to change specifications for product improvements without notification.