User Manual

Suggested Owners Manual Text for Gentex Auto-Dimming Mirror with HomeLink
®
3. Simultaneously press and hold both the HomeLink
®
and hand-held transmitter
button. DO NOT release the buttons until step 4 has been completed.
4. While continuing to hold the buttons the red Indicator Status LED will flash slowly
and then rapidly after HomeLink
®
successfully trains to the frequency signal from the
hand-held transmitter. Release both buttons.
5. Press and hold the just-trained HomeLink
®
button and observe the red Status
Indicator LED. If the indicator light stays on constantly, programming is complete
and your device should activate when the HomeLink
®
button is pressed and
released.
6. To program the remaining two HomeLink
®
buttons, follow steps 2 through 5.
Rolling Code Programming
Rolling code devices which are “code-protected” and manufactured after 1996 may be
determined by the following:
• Reference the device owner’s manual for verification.
• The handheld transmitter appears to program the HomeLink Universal Transceiver
but does not activate the device.
• Press and hold the trained HomeLink button. The device has the rolling code feature
if the indicator light flashes rapidly and then turns solid after 2 seconds.
To train rolling code devices, follow these instructions:
1. At the garage door opener receiver (motor-head unit) in the garage, locate the
“learn” or “smart” button. This can usually be found where the hanging antenna wire
is attached to the motor-head unit. Exact location and color of the button may vary
by garage door opener brand. If there is difficulty locating the training button,
reference the device owner’s manual or please visit our Web site at
www.homelink.com.
2. Firmly press and release the “learn” or “smart” button (which activates the “training
light”). Note: There are 30 seconds in which to initiate step3.
3. Return to the vehicle and firmly press, hold for two seconds and then release the
desired HomeLink
®
button. Repeat the “press/hold/release” sequence a second
time to complete the programming. (Some devices may require you to repeat this
sequence a third time to complete the programming.)
4. Press and hold the just-trained HomeLink
®
button and observe the red Status
Indicator LED. If the indicator light stays on constantly, programming is complete
and your device should activate.
5. To program the remaining two HomeLink
®
buttons, follow either steps 1 through 4
above for other Rolling Code devices or steps 2 through 5 in Standard Programming
for standard devices.
Gate Operator & Canadian Programming
During programming, your handheld transmitter may automatically stop transmitting.
Continue to press the Integrated HomeLink
®
Wireless Control System button (note
steps 2 through 4 in the Standard Programming portion of this document) while you
press and re-press (“cycle”) your handheld transmitter every two seconds until the
frequency signal has been learned. The indicator light will flash slowly and then rapidly
after several seconds upon successful training.