Installation Guide

Page 2/2
Fig.3
C
US
1:There have two LED module with this fixture ,if
one of them is no work ,replace it as shown
in Fig. 3, make sure the power is off before you
replace ;
2:Twist off the screw (H) which at the top of lamp
body with screw driver ,take off the shade (K)
carefully ;
3: Disconnect the wire nut (I), cut a short section of
cable wire if necessary , be careful not to damage the
other insulation jacket of the inner wire when
stripping bare strands of 1/2".
4:Cut the PC cable ties (J)of the no work moule ,
replace a new one;
5:repeat step 4-1 to assemble the fixtuer.
Your replace is now complete , return power to the
junction box and text the fixture
LED module replace(Fig.3)
Shut
off power before replacing
H
I
J
L
K

WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER
AVERTISSEMENT!COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DO DISJONCTEU

READ AND SAVE THESE INSTRUCTIONS
For LED Pendant
INSTALLATION INSTRUCTIONS FORP1154-655-L