Installation Guide

INSTALLATION INSTRUCTION FOR FIXTURE #P1373-613
MOUNTING THE FIXTURE (FIG. 1)
1. Shut off the power supply at the fuse box or circuit
breaker. If necessary, remove the old fixture from wall.
Including the mounting hardware.
2. Carefully remove the new fixture from the carton and
check that all parts are included as shown in the
illustration.
3. Lift mounting plate (B) to outlet box so that the screw
holes in outlet box line up with slots on mounting plate
(B), mark spots at outer keyholes for the plastic anchors
(A) to be installed.
4. Drill pilot holes on spots marked and insert plastic
anchors (A). (If fastening with wood screws to stud,
ignore this step)
5. Attach mounting plate (B) to outlet box using the outlet
box screws (E) (SIZE: #8-32N * L0.5”).
6. Attach ends of mounting plate (B) to plastic anchors (A)
or the spots that you marked on stud and secure with
four wood screws (D).
CONNECTING THE WIRES (FIG. 2)
7. At this point, connect the electrical wires as shown in
Fig. 2, making sure that all wire nuts are secured. If your
outlet box has a ground wire (green or bare copper),
connect the fixture’s ground wire to it. Otherwise,
connect the fixture’s ground wire directly to the mounting
plate (B) using the green ground screw provided.
8. Tuck the wire connections neatly into the wall outlet box.
ASSEMBLE THE FIXTURE (FIG. 1)
9. Attach the backplate (F) onto the mounting plate (B) by
protruding 2 mounting screws (C) through the mounting
holes of the backplate (F) and secure with the finials (H).
10. Install the light bulbs (not included) in accordance with fixture’s
specifications. (DO NOT EXCEED THE MAXIMUM WATTAGE
RATING!) (NE PAS DEPASSER LA PUISSANCE NOMINALE
MAXIMALE!).
Your installation is now complete. Return power to the
junction box and test the fixture.
Fig.1
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
Fig.2