Instructions / Assembly

ManualsBrandsGeorge Kovacs ManualsLightingAlluria 1-Light Weathered Coal and Autumn Gold Mini Pendant with Etched Opal Glass Globe Shade

INSTALLATION INSTRUCTIONS

Item#P351-618 (New. 11/19/2019)

READ AND SAVE THESE INSTRUCTIONS

W A R N I N G ! S H U T P O W E R O F F AT F U S E O R C I R C U I T B R E A K E R .

AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.

Page: 1/1

Fig. 1

Fig. 2

LA-3161E

PREPARATION (Fig. 1)

1. Shut off

power at the fuse box or circuit breaker box and

remove the old fixture including the mounting hardware.

2. Carefully unpack your new fixture and lay out

all the

parts in a clean area. Take care not to misplace any

small parts necessary for installation.

ASSEMBLING THE FIXTURE (Fig. 1)

3. Determine the desired hanging height and thread rods

(F1, F2 and F3) to threaded nipple (G) on the fixture

body. Attach canopy (D) by screwing onto rod (F1).

Carefully pass the wires through each rod during

assembly. Note: Remove the threaded nipple, if

installing with one 6” rod only.

4. Thread screws (A) into the pre-drilled holes in the

circular strap (B) spaced the same distance apart as the

holes in the canopy (D).

5. Attach the circular strap (B) to the outlet box using

mounting screws (C) (Size: #8-32N*L0.5”). The side of

the circular strap marked “GND” must face out.

CONNECTING THE WIRES (Fig. 2)

6. Connect the electrical wires as shown in figure 2

making sure that all wire connectors are secured.

If your

outlet has a ground wire (green or bare copper), connect

the fixture’s ground wire to it

. Otherwise, connect the

fixture’s ground wire directly to the circular strap (B)

using the green screw provided.

7. Tuck the wire connectors neatly into the ceiling outlet

box.

COMPLETING THE INSTALLATION (Fig. 1)

8. Slide screws (A) through canopy (D)

and secure with

decorative nuts (E).

9. Install the one G9 bulb (I) (included) up to 75 watts each

or CFL or LED equivalent

in accordance with the

fixture’s specifications.

(DO NOT EXCEED THE

MAXIMUM WATTAGE RATING!). (NE PAS DEPASSER

LA PUISSANCE NOMINALE MAXIMALE!).

10. Raise the glass shade (J) to socket cup (H) and twist

secure.

Your installatio

n is now complete. Return power to the

outlet box and test the fixture.

Note:

Illustration (Fig. 1) on this manual is for

installation purposes only. It may or may not be

identical to the fixture purchased.

IMPORTANT: FIXTURE SHOULD BE INSTALLED BY

A QUALIFIED ELECTRICIAN TO ENSURE PROPER

WIRING AND INSTALLATION.

FIXTURE

WIRES

Black or

Smooth

HOUSE

WIRES

Black

(Hot)

FIXTURE

WIRES

White or

Ribbed

HOUSE

WIRES

White

(Neutral)

FIXTURE

WIRES

Bare

Copper

(Ground)

HOUSE

WIRES

Green

(Ground)

Set# A-020

-Circular strap

-Ground screw

-Mounting screw*2

Rod# W30-1-66*1(F1)

W30-1-66*2(F2)

W30-H-66*1(F3)