Installation Guide

INSTALLATION INSTRUCTIONS FOR P5042-X-L
For Wall Mount Fixture
WARN I NG ! S H UT PO W E R O F F AT F USE O R CIRC UIT BR E AK E R.
AV E R T I S S E M E N T ! C O U P E R L E C O U R A N T A U N I V E A U D E S F U S I B L E S O U D O D I S J O N C T E U R .
PREPARATION
1. Shut off power at the fuse box or circuit breaker box. If
necessary. Remove the old fixture and mounting
hardware.
2. Carefully unpack your new fixture and lay out all the
parts on a clear area. Take care not to lose any small
parts necessary for installation.
MOUNTING THE FIXTURE (FIG. 1)
3. Secure mounting back plate (A) to the outlet box
using junction box screws (B) (Size: 8-32*1/2”L). The
side of the mounting back plate marked “GND” must
face out.
CONNECTING THE WIRES (FIG. 2)
4. At this point, connect the electrical wires as shown in
Fig. 2, making sure that all wire connectors are
secured. If your outlet has a ground wire (green or
bare copper), connect the fixtures ground wire to it.
Otherwise, connect the fixture ground wire directly to
the mounting plate (A) using the green screw
provided. After wires are connected, tuck them
carefully inside the junction box.
5. Align the fixture’s back plate (C) over the mounting
back plate (A) and secure with screws (D) (Size：
'M4*8MM).
FINISHING THE INSTALLATION (FIG.1)
6. Carefully slide the glass shade (H) (PG5042) into the
front bracket (E). While supporting the glass, attach
glass holder (F) to the front bracket (E) with screws
(G) to secure the glass in place.
CAUTION/ATTENTION: When handling the fixture, do
not apply pressure to the LEDs, Hold the fixture by the
base or front bracket (E) only.
IMPORTANT: Fixture should be installed by a qualified
electrician to ensure proper wiring and installation.
Dimmable with C-L (CFL & LED) type and
Incandescent/Halogen type dimmers
Replacing LED module (Fig. 3)
The LED module can be replaced by a qualified
electrician without cutting of wire and without damage to
any decorative element to which the fixture is attached.
See installation steps for more details (Fig 3.)
a. Shut off the power.
b. Remove screws (G) glass holder (F) and glass shade
(H).
c. Remove the wire nuts located inside the fixture
backplate to disconnect the LED module.
d. Remove screws (N) on bracket (E). Carefully remove
the LED module (I) from bracket (E),
e. Reverse steps a-c for installing the new LED module.
f. Note: The LED module should be provided by a
specified supplier.
g. For better heat dissipation the LED module (I) should
be applied with thermal grease when re-lamping.
Brand : Lutron
Brand : Leviton / Model number : Sureslide 6615
Fig.2
FIXTURE
WIRES
Black or
Smooth
HOUSE
WIRES
Black
(Hot)
FIXTURE
WIRES
White or
Ribbed
HOUSE
WIRES
White
(Neutral)
FIXTURE
WIRES
Bare
Copper
(Ground)
HOUSE
WIRES
Green or
Bare
Copper(G
round)
Fig.3
N HI
GFEDC
FIG.1
Outlet BOX
A
B
C
D
E
F G
H
White wire
Black wire
I
J
Set A# : A-021-125D
Back plate
Green screw
Mounting Screws(2)
MIN 90°C SUPPLY CONDUCTORS
LES FILS D’ALUMENTATION 90°C MIN