Installation Guide

INSTALLATION INSTRUCTIONS FOR P5042
For Wall Mount Fixture
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER .
AVERTISSEMENTI！COUPER LE COURANT AUNIVEAU DE FUSIBLES OU DU DISJONCTEUR
PREPARATION
1. Shut off the power at the circuit breaker box
(avertissement! couper le courant au niveau des
fusibles ou du disjoncteur) and remove the old
fixture, including the mounting hardware.
2. Carefully unpack your new fixture and lay out all
the parts on a clear area. Take not to loose any
small parts necessary for installation.
MOUNTING THE FIXTURE (FIG. 1)
3. The circular strap（part#A-021R-110） contains
several pairs of threaded holes. Find the pair of
holes that match the hole spacing in your fixture
canopy and thread the two mounting
screws(Size:8-32*1/2”L) part way into the
circular strap. Secure the circular strap to the
outlet box (not provided) with mounting screws
through slotted holes in circular strap.
4. CONNECTING THE WIRES (FIG. 2)
5. At this point, connect the electrical wire as shown
in Fig. 2, making sure that all wire connectors are
secured. If your outlet has a ground wire (green
or bare copper), connect the fixtures ground wire
to it. Otherwise, connect the fixture ground wire
directly to the circular strap using the green
screw provided. After wires are connected, tuck
them carefully inside the junction box.
6. Install the proper light bulbs(2-60W TYPE T10) for
your fixture,
DO NOT EXCEED THE SPECIFIED WATTAGE!
（ NE PAS DEPASSER LA PUISSANCE
NOMINALE MAXIMALE）
7. Place the glass over the socket and secure by turning
clockwise.
Return the power to the junction box and test the fixture.
Your installation is now complete.
IMPORTANT: Fixture should be installed by a qualified
electrician to ensure proper wiring and installation.
Fig.1
II299