Installation Sheet

ManualsBrandsGeorgia Pacific ManualsCommercialRecessed Trash Receptor for 16" Cavity - Less Dispenser

enMotion

Recessed Automated Touchless Towel Dispenser

Installation Instructions for New and Retrofit Construction

This manual is designed to assist you in the installation of the

Georgia-Pacific enMotion Recessed Automated Touchless Towel Dispenser.

Below you will find several different application procedures. If you should

have any questions, please contact our Installation Support Team at

1-877-377-2737.

NOTE:

The following tools are necessary to properly complete this installation:

• Cordless drill and Phillips head drill bit

• Hammer

• Vise grip pliers

• Masking tape

• Sheetrock saw

• Two drift pins: one 1/32” and one 1/16” diameter

• #10 pan head self-tapping screws

Georgia-Pacific professional installation available at no cost for

20 units or more.

Georgia-Pacific makes no representations or warranties of Bobrick Washroom Equipment, Inc.

(“Bobrick”).

The installation description and illustration herein are to serve as a guide. Georgia-Pacific reserves

the right and does from time to time make changes and improvements in design, dimensions and

subsequent installation instructions. Georgia-Pacific does not take responsibility for any damage,

or injury to persons or property or any other incidental or consequential losses due to these instal-

lation instructions.

Summary of content (6 pages)

PAGE 1
enMotion Recessed Automated Touchless Towel Dispenser ® Installation Instructions for New and Retrofit Construction This manual is designed to assist you in the installation of the Georgia-Pacific enMotion Recessed Automated Touchless Towel Dispenser. Below you will find several different application procedures. If you should have any questions, please contact our Installation Support Team at 1-877-377-2737.
PAGE 2
Installation of enMotion Recessed Automated Touchless Towel Dispenser into Sheetrock Wall Locate stud in wall and cut hole to accommodate enMotion Recessed Automated Touchless Towel Dispenser. Cut hole that is 10-5/8” wide by 15-3/16” length. (See Fig. 1) Install and fit enMotion Recessed Automated Touchless Towel Dispenser into wall cavity. Fig. 1 Ensure enMotion Recessed Automated Touchless Towel Dispenser is attached to stud or frame cavity as necessary.
PAGE 3
”The Perfect Fit“ Cabinet Installation Cabinet dimensions required 10-5/8” x 15-1/4”. Remove existing dispenser. (If Bobrick unit, see removal instructions below.) Tap Hinge Pin to expose at bottom of hinge. (See Fig. 1) Pull Hinge Pin straight down to remove. (See Fig. 2) Fig. 1 Install and fit enMotion Recessed Automated Touchless Towel Dispenser into cavity. (See Fig. 3) Locate mounting slots inside enMotion Recessed Automated Touchless Towel Dispenser.
PAGE 4
7
PAGE 5
ASI/Bobrick Roll Towel – Center Mount Installation (Requires Custom Filler Panel) Step 1: Removing Door from Existing Cabinet Apply masking tape above and below the hinge to protect the cabinet while removing the door. (See Fig. 1) With door closed and locked (some ASI units require the door to be open), drive the hinge pin down from the top using a drift pin and hammer. (See Fig. 2) Grip the bottom of the hinge pin with vise grip pliers and pull down to remove.
PAGE 6
Step 3: Installation of the New enMotion Recessed Automated Touchless Towel Dispenser Since this cabinet is very deep and wide, it will be necessary to install wood shims on each side and in the back of the cabinet in order to secure the new enMotion Recessed Automated Touchless Towel Dispenser. (See Fig. 5) Remove the plastic protective film from the Custom Filler Panel. Apply two-way tape to the inside flanges Filler Panel.