Installation Sheet

Table Of Contents

Operation Manual

DANZE ALWAYS RECOMMENDS THAT PLUMBING PRODUCTS BE INSTALLED BY A LICENSED PROFESSIONAL.

Danze’s 3/4” volume control is designed to be installed with

Danze’s 3/4” Thermostatic Mixing Valve (D155000BT). The

3/4” Volume provides the on/off control as well as flow

control to a specific shower function (such as a showerhead,

handshower or body sprays) while the 3/4” Thermostatic

Mixing Valve provides only temperature control. Usually, one

to three 3/4” Volume controls are installed with one 3/4”

Thermostatic Mixing Valve.

DO NOT USE DANZE 3/4” VOLUME CONTROLS WITH

DANZE 1/2” INTEGRATED THERMOSTATIC VALVES

(D150000, D151000) OR DANZE PRESSURE BALANCE

VALVES (D112000, D113000, D115000). The use of Danze’s

3/4” Volume Controls with a pressure balance or integrated

thermostatic mixing valve may cause damage to the mixing

valve and/or lead to thermal shock.

The valve is marked with arrows cast into the brass showing

the direction of the water flow. The water coming from the

mixing valve must enter the volume control valve through the

inlet port.

Install water supply piping and discharge piping to valve. Do

not solder the supply or outlet pipes directly to this rough

valve. Use the appropriate 3/4” NPT copper fitting and sweat

or connect pipes to fitting.

The minimum recommended distance from thermostatic shower

discharge port to inlet port of diverter is 4 13/16" (122 mm) to

assure proper clearance of the shower valve escutcheon and

thermostatic valve escutcheon.

Note: The back of valve

should be 3 7/16" (88 mm) to 4 1/4" (108 mm) away from

finished wall surface.

3/4"-14NPT-FIP

3/4"-14NPT

Volume control valve

3/4" thermostatic mixing valve

Finished wall surface

3 7/16"~4 1/4"

(88mm~108mm)

Ø1 3/4"~Ø2 3/8"

(Ø45~Ø60mm)

4 13/16"~6 13/16"

(122~173mm)

8"~10"

(203~254mm)