Installation Sheet

Adjustable

Wrench

Llave ajustable

Pince à bec effilé

Clé à molette

Needle-nose Pliers

Alicates de extremos finos

Shown/Mostrado/Illustré

Pomme de douche

Cabeza de ducha

Mono Round Showerheads

Remove the existing showerhead from the showerarm. Clean the debris from

the inside of the showerarm and the showerarm threads. Run water to flush

the residual debris from the inside arm (Fig 1).

2. Wrap the threads of the showerarm with the plumber's tape (included) (Fig 2).

Attach the new showerhead to the showerarm by turning clockwise. Tighten

with a wrench (Fig 3 & 4).

D460051, D460052

D460053, D460054

PAGE 1
Mono Round® Showerheads Cabeza de ducha Pomme de douche Adjustable Wrench Needle-nose Pliers Llave ajustable Alicates de extremos finos Clé à molette Pince à bec effilé 1. Remove the existing showerhead from the showerarm. Clean the debris from the inside of the showerarm and the showerarm threads. Run water to flush the residual debris from the inside arm (Fig 1). 2. Wrap the threads of the showerarm with the plumber's tape (included) (Fig 2). 3.
PAGE 2
the 1. Remove the showerhead from the showerarm by unscrewing the ball joint counter-clockwise (Fig 1). 2. The filter screen and flow controller are located at the opening of the showerhead ball joint (Fig 2). Unscrew the filter screen from the ball joint. If necessary, use your needle-nose pliers (Fig 3). 3. Use needle-nose pliers to grasp the flow controller and pull the flow controller out. Take care not to use excessive force when grasping the flow controller so as to avoid damage (Fig 4). 4.
PAGE 3