Installation & Assembly

Prior to installing the handle on the thermostatic valve

stem, make sure the high temperature limit over-ride

button is aligned with the gun sight on the limit stop

(see illustration). Note the gun sight on the limit stop

indicates factory calibration for high temperature limit

at 100 ºF (38 ºC).

Install the screw in the thermostatic handle and tighten

by hex wrench (supplied), then attach the handle cap.

ADJUST TEMPERATURE SETTING

• Hot and cold water pressure = 45 psi ( 3 bar) • Hot water temperature = 149˚ F or 65˚C • Cold water temperature = 59˚ F or 15˚C

The valve is calibrated at the factory to deliver water at approximately 100˚F (38˚C) when the handle is positioned at the “High

Temp Override Position” (Shown in Figure 5). This temperature roughly corresponds to the 100˚F graduation line found on the

temperature dial of the valve trim and the reference mark found on the cartridge spline of this valve. Note the listed water

temperature settings are based upon our factory conditions as follows

If another range of temperatures is desired or the actual water supply conditions differ significantly, you will need to recalibrate the

valve settings according to the re-calibration procedure shown in 7.2–A shown below. If a maximum hot water temperature is

required, you also may need to re-calibrate the valve to meet your required maximum temperature output. See Setting a

Maximum Output Temperature in section 7.2 - B.

CAUTION: RISK OF SCALDING HAZARD

The valve has been calibrated at the factory to deliver water at approximately 100˚F (38˚C) at the High Temperature Override

Position. This temperature corresponds to the line marked on the valve cartridge stem. Based on the temperature and pressure

inputs used at our factory to calibrate the valve, the maximum outlet temperature is approximately 120˚F (49˚C). For calibration,

Danze assumes cold water supply to be 59˚F (15˚C) +/- 5˚F, and hot water temperature supply to be 149˚F (65˚C) +/- 5˚F. Both

hot and cold water pressure are 45psi. Any significant variation in the calibration, or any variation in the water supply

temperatures (greater than 5˚F or 3˚C) from those used at the factory during the calibration procedure, can result in water

temperatures that could present scalding dangers. It is important to check the water temperature with the temperature stem rotated

to the full counterclockwise (open) position to determine the maximum temperature of the water that will be delivered. The

responsibility for the proper installation and any recalibration of this valve lies with the installer.

Over-ride button is in line with the gun sight.