User's Manual

24 GS750
plus
Pen Holder and Pens
The pen holder shipped with a black pen installed. After loading
the plotting paper, install the pen holder in the carriage spindle as
follows:
To install the pen holder
1. Select the pen holder with pen installed from the tool rack
molded in the rear cover.
2. A plastic lift washer is used to reduce friction between the tool
holder and the lift fork of the carriage spindle during operation.
There should be one installed on the pen holder. If not, slip a
lift washer from the Tool Kit over the barrel and slide the
washer to the top of the holder.
3. Drop the pen holder into the carriage spindle. A slot, or
keyway, in the barrel of the pen holder ensures proper
orientation. If necessary, rotate the pen holder until it drops
completely into the carriage spindle.
4. When the pen holder is in place, swing the tool force arm and
snap it over the cone-shaped cap.
5. For plotting, start with a tool force setting between .5 and 1.
(See
PlotterUserReferenceCard .) If the pen does not make
a clear, dark line, increase the tool force setting.