User's Manual

Operation 43
Controlled Stop
Use RUN CONT (or RUN SINGLE) to pause plotting and check
the current job.
To stop a continuous mode plot
Press either RUN key. The GS750
plus
stops the plot at the next
logical break in the program. Do not use slew keys or
orientation for the current job will be lost.
1. Press either RUN key to resume plotting at the exact same
point.
Continuous Plot Exercise
1. Turn on the GS750
plus
. Load plotting paper, install the pen
holder, and set the tool force to .5.
2. Select either swivel or tangential knife mode by pressing the
SWIVEL KNIFE key. When swivel knife mode is selected, the
light above the SWIVEL KNIFE key is on.
3. Using the slew keys, position the carriage spindle
approximately 1" from the front edge of the plotting paper. Be
sure that there are several inches of paper extending past the
carriage spindle and to the left of the plotter.
4. Prepare two plot files. If using a GRAPHIX ADVANTAGE to
prepare the files, in the Plot Program choose a left Start
Position and a right End Position for both plots before sending
them to the plotter. This will prevent the files from plotting on
top of each other. If using another layout program, be sure to
position the files so they will not plot on top of each other.
Note: Entering an X,Y pre-position in the Plot Program is
another way to be sure that plots done in the RUN CONT
mode will not plot on top of each other. (See GRAPHIX
ADVANTAGE Reference.)
5. Press the RUN CONT key. Both jobs will plot without a pause
between them.