User's Manual

44 GS750
plus
RESET KEY
Use the RESET key to stop plotter operation in case of
emergency, to clear error signals, and to access Special
Diagnostics.
To cause an emergency stop
Press the RESET key while a job is plotting. The following
sequence occurs:
1. GS750
plus
operation stops immediately.
2. The current job is cleared. All other jobs in the queue remain
intact.
3. The GS750
plus
returns to off-line status, as at power-up.
To clear an error signal
Press the RESET key to clear an error signal (steady tone and
flashing lights) after a power-up or plotting failure. (See the "Error
Conditions" section.)
To access diagnostics
Hold the RESET key at power-up to access additional diagnostics.
(See the "Special Diagnostics" section.)
RESET