Operation Manual

DATA MANAGER - GET DATA ACQUISITION SOFTWARE rev. 01

ENGLISH

3.2.12 Visualization modes

From the analysis window, it is possible to set two different visualization modes: the position mode (useful for

quick navigation through the laps of the session being analysed) and the measurement mode. As the default

setting, the software starts up in position mode. To move from one mode to the other quickly, simply double-

click on the analysis window or press the spacebar.

3.2.12.1 Position mode

The position mode is used as the default mode when the MX2 software is run and allows the user to choose

which of the graph areas to analyse quickly. There are three different methods for moving the graphs inside

the analysis window:

• by moving the selection square in the overview window, displaying the graphs of the channels in the

corresponding interval. Note that, when using this method, the current lap (shown in the tab of overview

window) is also changed if the selection square of the overview bar is moved onto a different lap.

• by moving the coloured lap rectangles in the lap bar, located above the analysis window. Also in this

case, the graphs of the channels are displayed in the corresponding intervals, and the current lap

(shown in the tab of overview window) is also changed if the rectangle is moved onto a different lap.

• by clicking on the analysis window and dragging the mouse to the right or to the left, the graphs scroll to

the side. In this case, the current lap (shown in the tab of overview window) is not change if the graphs

are dragged onto a different lap.

LAP BAR

OVERVIEW

WINDOW