Operation Manual

DATA MANAGER - GET DATA ACQUISITION SOFTWARE rev. 01

ENGLISH

3.2.16.3 Comparing the laps

If more than one lap is added to the project, the analysis window superimposes the graphs of different laps,

dividing them by channel. In this way, it is possible to analyse the values of the channels belonging to

different laps instant by instant. Use the alignment options described in the previous paragraph to move the

individual graphs to the desired position, then use the measurement mode to read the values of the channels

in the position indicated by the cursor.

3.2.16.4 Zoom on the analysis window

One of the options offered by the MX2 software is that of performing a zoom on the analysis window, in order

to enlarge a particular portion of the window or make a wider interval of time or space visible.

There are different methods for performing a zoom:

• Using the zoom in and zoom out buttons present on the toolbar ( )

• Using the mouse scrolling function

• With the + and – keys on the numerical keypad on the keyboard

• Using the Z key on the keyboard to zoom-in and the A key on the keyboard to reset the zoom on the

current lap.

The zoom on the current lap can also be reset using the designated button on the toolbar.

In measurement mode, the zoom is performed at the position of the cursor, so that it is always positioned in

the centre of the analysis window. In position mode, on the other hand, the zoom is performed using the part

of the analysis window displayed as reference.

It is possible to zoom in on a specific area of the analysis window, by clicking on the corresponding button on

the toolbar, then clicking on the graph and dragging the mouse horizontally, in order to draw the selection

rectangle for the zoom.