Operation Manual

DATA MANAGER - GET DATA ACQUISITION SOFTWARE rev. 01

ENGLISH

3.2.18.1 Creating a new report

In order to create a new report, simply right-click on the Report window and select the heading Report

management. The window for creating a new report is then displayed.

The controls at the top of the window allow the user to manage the tabs of the report window. As with the

analysis window (see chapter 6.4.4), in this window it is also possible to divide the elements into different

tabs in order to obtain a personalised display of the reports.

In order to select the tab on which to create the report, click on the Current Tab selection control and

choose the tab required (if present, otherwise it is necessary to create a new one). The buttons immediately

to the left, New tab, Delete tab, Rename tab, allow the user to create a new tab, delete a previously created

tab or change the name of an existing tab respectively.

The bottom of the window, on the other hand, allows the user to configure the report to be created. To

configure a report, proceed as follows:

• Select one of the sessions in the Sessions present area. Here, all the sessions loaded in the analysis

window are shown.

• In order to select the laps, click on one of the headings in the Configure laps box:

All: all the laps are selected.

Best: the lap with the best time is selected.

Choose: selecting this heading activates the window below where it is possible to choose the desired

lap.

• In the Configure segments/sectors box, select one of the headings:

Sectors: which represent the split times (SP1, SP2, etc. ).

Segments: which represent the stretches which the track has been divided into, using the Segments

function which can be accessed from track management (see chapter 6.9.6).

• Select the channel from which the report is to be taken in the Available channels area.

• In the Functions box, select the type of function to be applied to the report:

Min: restores the minimum value present in the chosen channel and in the selected acquisition stretch.

Max: restores the maximum value present in the chosen channel and in the selected acquisition stretch.

Avg: restores the average value of the selected channel.

In: restores the value of the channel at the moment of entry into the selected acquisition stretch.

Out: restores the value of the channel at the moment of exit from the selected acquisition stretch

Delta: restores the channel difference, typically used for system channels such as:

- Lap time

- Time, the overall acquisition time.

- Lap distance, the length of the lap.

- Distance, the length of the whole acquisition.

In order to select these elements from the report creation window, double-click on the headings to add. Each

heading selected from the report creation window is displayed in bold and will appear on the report window

summary. Once the headings required have been chosen, click on OK and wait for the report to be created.

TAB MANAGE.

CONTROLS