User manual

12
automatically shuts o.
c) Monitor time: Approximately 30 seconds
When outside camera is activated from the inside,
there is approximately 30 seconds of viewing time
before the unit automatically shuts o.
4. Activation of “Intercom” button

An intercom calling can be started by any indoor monitor
when it is on standby mode.
When the intercom button

on either indoor monitor is
touched, this will ring all monitors in a system. You can
talk with the calling monitor by touching the

button
on the second monitor. Touch

for shutting of again.
There is approximately 60 seconds of time before the unit
automatically shuts o.
5. Activation of

button
Door open:
If an electrical lock or door strike is added to the
installation, connect it to the terminals at the back of the
roadside panel.
If you want to open the door to let the caller in, just touch
the

button on the indoor monitor.
This function can only be used when the screen is
switched on. It is normal that the image switches o one
moment following the control of the door open.
Important: It is essential that the electric latch or lock
installed has a mechanical memory.
6. Activation of

button
Gate open:
Connect the gate opener directly to the terminals at the
back of the roadside panel which supplies a current-free
“dry” contact to connect to the “push button” control of
your automatic gate opener.
If you want to open the gate to let the caller in, just touch
the

button on the indoor monitor.
This function can only be used when the screen is
switched on. It is normal that
the image switches o one moment following the control
of the gate opener.
7. Change the melody
At standby mode, touch the

button, you can hear the
melody. Then touch

to choose your desired melody.
There are 4 melodies available. To confirm the melody of
your choice, touch

button again.
8. Mute on/Mute o / Night Modus / Silent Modus
At standby mode,touch the

button, the pictogram

shifts from blue to red. When the monitor's status is
Mute on, there will be no melody, while other functions
will be normal. To reactivate the ring tone, touch

button,the pictogram

shifts from red to blue.
Extending your system/ Cofiguring your system
Thisy system can be extendend in several ways- e. g.
by adding more indoor or outdoor units. Please refer to
the wiring diagrams for installation. Please take not of
the jumper settings in the wiring diagrams. It is essential
that you adopt the Jumper settings according to the
information in the diagrams.
The jumpers are to be found on the backside of the indoor
unit and are marked with the letters M (Master) and S
(Slave). Both Jumper up mean Master unit, both jumpers
down mean slave unit.
Care and Maintenance
• Do not store in hot or cold areas. Extreme hot or cold
temperatures can shorten the life of electronic devices and
can distort/melt certain plastics or may cause malfunction.
• Dropping can result in failure to operate. Circuit boards
can crack and may not survive the impact.
• Do not use or store in areas of high levels of dirt or dust.
The electronics may be contaminated. Any moving parts
will wear prematurely.
• Do not use harsh chemicals, cleaning solvents or strong
detergents. To clean, wipe with a damp cloth from time to
time.
Recycling Instructions
Waste electrical products should not be disposed of
with household waste. Please recycle where facilities
exist. Check with your Local Authority or retailer for
recycling advice.