User manual

Clone mode after enter the operating system.

If only connected CRT display device, the default display mode is the Intel ⑵

(R) Dual Display Clone mode, the best resolution if the display is greater than

1366X768, will not achieve the best resolution display devices, display devices

need to manually set the most good resolution

Steps: right click desktop -> click “screen resolution” -> Settings "resolution"

If HDMI and CRT display devices were connected at the same time, the ⑶

default display mode is the Intel (R) Dual Display clone mode, the maximum

resolution can be up to 1366x768 (can also set other higher resolution, but the

HDMI display will be missed)..

If the problem can’t solved even after the above measures are taken, you may

contact our customer service center or log in the official forum of Giada.

Please prepare the materials listed below before you contact so as to receive

prompt service from us.

• True product name and model;

• Product code and its serial number;

• Date of purchase;

• Brief introduction of the problem on your PC;

• Information concerning the software and other external hardware.

Changes or modifications not expressly approved by the party responsible for

compliance could void the user's authority to operate the equipment

NOTE: This equipment has been tested and found to comply with the limits for

a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are

designed to provide reasonable protection against harmful interference in a

residential installation. This equipment generates, uses and radiates radio

frequency energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio communications.