Operation Manual

Lombok A130/AL130A/A230/AL230A / Großbritannien / A31008-M2412-L101-1-7619 / Lombok.fm / 11.08.2014
Version 4, 16.09.2005
6
Setting the date and time
Set the date and time so that the correct date and time can be assigned to incoming
calls, and so that the alarm can be used.
MENU ¤ u Settings ¤ OK ¤ Date/Time ¤ OK ¤ Date ¤ ~ (enter the day,
month and year in 6-digit format)
¤ OK ¤ Time ¤ ~ (enter hours and minutes in 4-
digit format)
¤ OK (display message: Saved)
¤ a (press and hold to return to idle status)
When entering the time and date, you can move the position of an entry to the left or
right by pressing the control key
u up or down.
Please note
◆ The handset is pre-registered with the base. If you have purchased a
model with multiple handsets, all handsets will already be registered
with the base. You do not need to register the handset again. The internal
handset number appears in the top left of the display, e.g.
1 (¢ page 1).
However, if a handset is not registered with the base (Register HS or Put
into base
is displayed), please register the handset manually
(¢ page 10).
◆ If you have purchased multiple devices, you can upgrade your Gigaset to
a cordless PABX by registering
all A130/A230 handsets at the same base
(¢ page 10).
◆ After the first battery charge and discharge, you may place your handset
in the charger after every call.
◆ Always repeat the charging and discharging procedure if you remove the
batteries from the handset and reinsert them.
◆ The batteries may warm up during charging. This is not dangerous.
◆ After a while, the charge capacity of the batteries will decrease for techni-
cal reasons.
Activating/deactivating the handset
Press and hold the a key to activate or deactivate the handset. If you place a deacti-
vated handset in the base station or charging cradle, it will automatically activate after
approx. 30 seconds.
If you remove the handset from the base station/charging cradle, the display turns off
briefly.
Making calls
Making external calls and ending calls
External calls are calls using the public telephone network.
~
(Enter the phone number) ¤ b.
The phone number is dialled. (Or you can first press and hold talk key b [until you
your the dial tone] and then enter the number.) During the call you can adjust the ear
-
piece volume using t and set the volume with u.
End the call/cancel dialling: Press the end call key a.
You can automatically insert a network provider dialling code before any phone num-
ber (¢ page 7).
Accepting a call
Press the talk key b to accept the call.
When Auto Answer is activated (see menu overview ¢ page 16), simply remove the
handset from the base station/charging cradle.
Please note
If your phone receives the date and time during calling line display (e.g., via your
network provider, a router or PABXs), you can specify whether this data should be
copied to your phone:
¤ Press the key sequence: MENU ¤
P#Q5#MI
The following is displayed;
the current setting flashes:
¤ Press one of the following keys to specify, when this data should be copied to
your phone:
Q Never
or
1 Once, in case the date/time is not set on your phone
or
2 Always
Your selection is displayed (e.g. 2 for "Always"):
¤ Press the display key OK.
973 SET:
[
0
]
973 SET:
[2]