Operation Manual
24
Operation
Once you have set up your baby monitor, you will be able to hear the sounds in your
baby´s
room through the parent unit. You will also be able to see those sounds as the sound sensor
lights on the parent unit, which rise and fall with the volume level.
If the connection between the parent unit and baby unit is broken at any time
the green “Link“
light on the parent unit will ash and you will hear short beeps. To re-establish the “Link“,
follow the directions in the “Troubleshooting“ chapter.
Note
Powering on/o the baby monitor
After having connected the baby monitor you will have to switch on both units.
Press and hold down the On/O key on each unit.
To switch o the unit press and hold down the On/O key again.
Parent Unit
• Long press On/O key
2 sec to turn on unit. Power LED will turn On in Green and then
ashing in 0.5s on and 0.5s o during linking. Antenna Icon is turned o.
• It becomes steady Green when linked. Antenna Icon
is turned on.
• It becomes ashing Green Flashing if linking failed. Antenna Icon is turned o.
Baby Unit
• Long press On/O key
2 sec to turn on unit. Power LED will turn On in Green and then
ashing in 0.5s on and 0.5s o during linking.
• It becomes steady Green when linked.
• It becomes ashing Green Flashing if linking failed.
en