Use and Care Manual

2
10
12
11
6
9
5
4
3
1
2
Steps Of Dismantling GPW-7
Disassembling Instructions Assembling Instructions


 Take off Air Regulator (1), Pull out
Rubber Glue (2).


 Loosen Shifting Post (3) and take it
off (remember to remove Water Inlet
Tube).


 Unscrew Locking Ring (4) and take
off Cylinder Assembly (5).


 Take out Pad (6).


 Loosen Locking Screw Cap (9) and
take off Spindle Assembly (10).


 Take off Water Inlet Transfer Pos
(11).


 Take off Oil Seal (12).


 Assemble Spindle Assembly (10)
and tighten Locking Screw Cap (9).


 Put Cylinder Assembly (5) in the
Housing.


 Tighten Locking Ring (4) and
Shifting Post (3) (with Water Inlet
Tube).


 Cover the Shifting Post with Rubber
Glue (2).


 Place Oil Seal (12) and Water Inlet
Transfer Pos (11) in the correct
position.


 Load Pad (6).


 WARNING ！
！！
！
Please follow above Disassembling and Assembling Instructions; otherwise the
Oil Seal (12) may be broken. It will cause water leaking and damage the tool.
A
B
C
D