Instructions / Assembly

7 Water testing and sealing testing、
Testing Purpose: Flush the impurities and sludge in the pipeline
to avoid clogging and affect the effluent functions.
1、After the pipe connection is completed, open the protective panel
and cover, and then open the cartridge, flush the pipeline;
then close the cartridge to check the pressure resistance and sealing
performance of the pipeline, make sure there are no leakage.
2、Block each outlet pipe with a stopper then open the cartridge to
check if the pipe joint is well-sealed and the pipe condition under
pressure to ensure no leakage.
6
8 The procedure of sealing the wall、
Use a parallel ruler to measure the flatness of the embedded box
casing and the vertical wall surface. If the wall surface is not flat,
it should be patched to ensure the embedded box casing and vertical
wall angle meets at nearly ideal angle of 90, then lay the tile decoration.
7
9 Installation of control valve、
1、Take off the protective panel and cover
2、The decorative panel and the handle are connected to
the control valve as shown below sequence.
8
9
12 Product reparation、
If the cartridge is worn out which cause leakage, please turn
off the water source. Remove the handle, panel, and decorative
cover in sequence, remove the gland with a wrench, then take
out the cartridge and copper sleeve.
Repair or replace the new cartridge, then install it again in sequence.
10
In order to keep the faucet appearance smooth and good
performance, please follow the below steps to clean and
maintain the faucet.
13 Clearance and Maintenance 、
1、Clean with water and dry with a soft cotton cloth；
2、Use a mild liquid and a colorless glass cleaner to remove surface
dirt and scale, also you can use the cleaner without grinding function.
3、Do not use detergents, polishing tools, abrasive cloth, paper towels
or scrapers to clean the faucet.
4、Do not use acid cleaners, insoluble granular detergents, soaps, etc
to clean the faucet.
11
10
10、Shower sets installation
11、Handle shower installation
According to the figure below, please correctly adjust
the direction of water separator handle
Handle shower
outlet water
Top shower
outlet water
wall
Tile surface
Protective cover is
roughly even with tile