Installation Guide

7 HOMEDEPOT.COM

Please contact 1-855-HD-GLACIER for further assistance.

Operation

Flushing and checking for leaks

□ Pull the hose assembly out of the spout and

remove the spray head by unscrewing it from

the hose in a counterclockwise direction. Be

sure to hold the end of the hose down into the

sink and turn the faucet to the warm position

where it mixes hot and cold water.

□ Flush the water lines for one minute. This ushes

away any debris that could cause damage to

internal parts. Check for leaks.

□ Re-tighten any connections if necessary, but do

not overtighten. Reinstall the spray head by hand

tightening it back onto the spray hose in a

clockwise direction.

IMPORTANT: After installation is completed, turn on the

hot and cold water supplies. Check for leaks. Do not lose

the gasket (1) in the hose.

Removing the quick connector

□ If it is necessary to remove the quick connector

(1), squeeze the tabs (2) on the quick connector

and then pull down to disconnect.

Squeeze

Pull

down