Installation Guide

7
HOMEDEPOT.COM/GLACIERBAY
Please contact 1-855-HD-GLACIER for further assistance.
Installation (continued) Operation
3
2
1
F
E
B
Weight
Location
Decal
Attaching the weight
9
Quick Connector Removal
If it is necessary to remove the quick
connector (G), push the quick connector
housing up, hold the housing together and
pull down.
CAUTION: Use caution when removing
the quick connector hose to prevent cutting
your hands.
2
Checking for leaks
1
Detach the pull-down spray (B) from the pull-down
spray hose (E). Hold the pull-down spray hose (E)
firm to prevent it from retracting into the faucet
body (A).
Ensure the handle is in the off position. Turn the
hot and cold water supplies on and check all
connections for leaks. If leaks are discovered, check
the connections to ensure they are tight and properly
secured.
Lift the handle to allow the water to run for
approximately one minute. This flushes away any
debris that could damage the internal parts.
Turn the water off and reattach the pull-down spray (B).
The pull-down spray (B) should be nested in the
faucet body (A).
Use a Phillips screwdriver to secure the weight (F)
at the lowest point on the pull-down spray hose (E).
The weight (F) should cover the weight location de-
cal on the pull-down spray hose (E).
Pull the pull-down spray (B) away from the faucet
body (A) and ensure the pull-down spray hose (E) is
not obstructed.