Installation Guide

HOMEDEPOT.COM
Please contact 1-888-774-8062 for further assistance.
Installation
1
PREPARING FOR INSTALLATION
NOTE: Before installation, make
sure all parts are present. Compare
parts with the Hardware Included list.
If any part is missing or damaged, do
not attempt to install the product.
□ Determine the desired mounting location,
and mark the wall where the unit will be
installed.
NOTE: For secure installation, the
unit must be mounted to at least one
wall stud.
2
CUTTING THE OPENING FOR
PLUMBING FIXTURES
NOTE: This step applies to vanity
cabinets with full back panels only.
□ Locate and mark plumbing on the back panel.
□ Drill a pilot hole through the back panel.
□ Use a keyhole saw to cut an opening for the
plumbing fixtures.
3
POSITIONING THE
CABINET
□ Move the cabinet into
place, and use wood
shims to level the
cabinet against the wall.
Use and Care Guide
Vanity Combo
TOOLS REQUIRED
Claw hammer Safety goggles
Phillips
screwdriver Power drill
Measuring tape Wall hardware Caulk/sealant Keyhole saw Level
HARDWARE INCLUDED
4
INSTALLING THE CABINET
□ For wall stud installation, insert #12 x 3 in. screws with
washers into the stud locations (not included).
□ For drywall installation, drill holes at the appropriate
locations and insert toggle bolts with washers (not included).
□ For concrete wall installation, drill 1/4 in. holes at the
appropriate locations and insert #12 wall anchors, followed
by #12 x 3 in. screws (not included).
5
INSTALLING THE VANITY TOP
IMPORTANT: Do not use plumber’s putty.
NOTE: The faucet, drain, and supply lines are not included. Install these
parts to the vanity top according to the manufacturer’s instructions.
□ Apply silicone caulk/sealant (not included)
to all four corners of the cabinet.
□ Place the vanity top onto the cabinet.
□ Position the top so that it has an equal
amount of overhang on each side and use a
level to ensure the vanity top surface is level.
□ Apply silicone onto the seam between the
edge of the vanity top and the wall, smooth
the bead, and allow to cure before use.
6
INSTALLING THE HARDWARE
□ Attach knobs (AA) to the drawers on the
vanity with screws (BB).
Item # 1001 353 276
Model # PPMDB24-JVM
AA - Knob BB - Screw
x 2 x 2
BB
AA