Installation Guide

ManualsBrandsGlacier Bay ManualsBathShaila 30-1/2 in. W Vanity in Silverleaf with Cultured Marble Vanity Top in White

INSTALLING THE HARDWARE

□ Attach the knob (AA) to the cabinet

with the provided screw (BB).

Use and Care Guide

Vanity Combo

Installation

PREPARING FOR INSTALLATION

NOTE: Before installation, make sure all parts are present.

Compare parts with the Hardware Included list. If any part is

missing or damaged, do not attempt to install the product.

□ Determine the desired mounting location, and mark the

wall where the unit will be installed.

NOTE: For secure installation, the unit must be mounted

to at least one wall stud.

POSITIONING THE CABINET

□ Move the cabinet into place,

and use wood shims to level the

cabinet against the wall.

Item# 1000 398 630, 1000 398 637

1000 050 591, 1000 398 605

1000 398 610, 1000 398 616

1000 050 588

Model# PPSOFGOK24, PPSOFGOK30, PPSOFSVL24, PPSOFSVL30

PPSOFWHT24, PPSOFWHT30, PPSOFTRF24

HARDWARE INCLUDED

AA - Knob x 2 BB - Knob screw x 2

TOOLS REQUIRED

Hammer Safety goggles Phillips screwdriver Power drill

Measuring tape Wall hardware Caulk/sealant Level

INSTALLING THE CABINET

□ For wall stud installation, insert #12 x 3 in. screws with

washers into the stud locations (not included).

□ For drywall installation, drill holes at the appropriate

locations and insert toggle bolts with washers (not included).

□ For concrete wall installation, drill 1/4 in. holes at the

appropriate locations and insert #12 wall anchors, followed

by #12 x 3 in. screws (not included).

INSTALLING THE VANITY TOP

IMPORTANT: Do not use plumber’s putty.

NOTE: The faucet, drain, and supply lines are not included. Install these

parts to the vanity top according to the manufacturer’s instructions.

□ Apply silicone caulk/sealant (not included) to all

four corners of the cabinet.

□ Place the vanity top onto the cabinet.

□ Position the top so that it has an equal amount of

overhang on each side and use a level to ensure

the vanity top surface is level.

□ Apply silicone onto the seam between the edge

of the vanity top and the wall, smooth the bead,

and allow to cure before use.

HOMEDEPOT.COM

Please contact 1-888-774-8062 for further assistance.

Summary of content (4 pages)

PAGE 1
Item# 1000 398 630, 1000 398 637 1000 050 591, 1000 398 605 1000 398 610, 1000 398 616 1000 050 588 Model# PPSOFGOK24, PPSOFGOK30, PPSOFSVL24, PPSOFSVL30 PPSOFWHT24, PPSOFWHT30, PPSOFTRF24 Use and Care Guide Vanity Combo TOOLS REQUIRED HARDWARE INCLUDED Hammer Safety goggles Phillips screwdriver Measuring tape Wall hardware Caulk/sealant Power drill AA - Knob x 2 Level BB - Knob screw x 2 Installation 1 PREPARING FOR INSTALLATION NOTE: Before installation, make sure all parts are present.
PAGE 2
Troubleshooting Problem Possible Cause Solution The doors do not align or the space is too big or too tight between the doors. The hinges are misaligned. Hold the door while loosening screws. Align the doors properly, and re-tighten the screws. Up — Down In — Out Left— Right Safety Information Please read and understand this entire manual before attempting to assemble, operate or install the product. Care and Cleaning □□ Use a water-dampened cloth to clean the cabinet. Avoid using abrasive cleaners.
PAGE 3
Núm. de artículo 1000 398 630, 1000 398 637 1000 050 591, 1000 398 605 1000 398 610, 1000 398 616 1000 050 588 Núm.
PAGE 4
Resolución de fallas Problema Posible causa Solución Las puertas no se alinean o el espacio es demasiado grande o está demasiado apretado entre las puertas. Las bisagras están desalineadas. Sostenga la puerta mientras afloja los tornillos. Alinee las puertas adecuadamente y apriete de nuevo los tornillos. Arriba — Abajo Adentro — Afuera Izquierda — Derecha Información de seguridad Por favor, lea y comprenda este manual completo antes de intentar ensamblar, operar o instalar el producto.