Installation Sheet

Install the Claw Hook Advanced

Bike Storage v3.0

IMPORTANT :

■ The Gladiator Claw™ Advanced Bike Storage v3.0 hook holds

either wheel of a bike.

1. Determine where you want to hang the bike. Engage the

storage hook mounting bracket into the wall slots by lifting up,

pushing toward the wall and lowering the bracket rims into the

slots.

2. Inspect the bike storage hook from the side to make sure the

mounting bracket rims are fully engaged in the slots.

3. Turn the lever lock counterclockwise to lock the storage hook

to the GearWall

panel or GearTrack

channel. Make sure the

lever lock is in the fully locked position, as shown.

4. Press the plunger until the hook arms are in the open position.

5. Lift the bike up and press the bike tire against the plunger. The

hook arms will close around the wheel. Make sure both arms

are completely closed around the wheel.

6. Remove the bike by lifting the bike up and pressing the tire

against the plunger. The hook arms will open to release the

bike wheel.

Install the Fishing Pole Hook

■ Designed to be used as a pair, the set of four shing pole

holders will support two shing poles mounted either vertically

or horizontally, as shown.

1. Install the shing pole holders into the slots in the GearWall

panel or GearTrack

channel so that distance between the

holders is one half the length of the shing pole.

NOTE : Engage the bracket rims into the slots by lifting up,

pushing toward the wall and lowering the rims into the slots.

2. Inspect the bracket from the side to ensure the rims are fully

engaged in the slots as shown.

3. Set the shing pole into the holders.

Claw Hook Advanced Bike Storage

Fishing Pole Hook (Vertical)

Fishing Pole Hook (Horizontal)

A. Lever lock

B. GearTrack

channel

C. Hook arm

D. Plunger